- Designed for fast removal of ferrous and non-ferrous tubes from Condensers, Heat Exchangers, and Boilers.
- Gripping and pulling done in single operation.
- Compact and lightweight pulling gun, easy to operate inside boiler drum with 24 Volt DC control.
- Auto ejection of tube after removal. Remove tubes without any damage to tube sheet.
- Auto Switchover from low-pressure high flow to high-pressure low flow on load and back again when load is released.
- Low setup time and ease of operation. Interchangeable pulling gun with same power pack.
- Significant savings of time & money over conventional methods of stub removal.
- Pneumatic version available for hazardous and explosive areas.
- Can pull from 15.8 mm to 50.8 mm I.D. tubes.
auto stub puller set
Note:5 meter long remote control and 5 meter long hose sets are supplied with the power pack.